skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing engine oil cooler > < Oil filter holder - Summary of components

Octavia Mk2

Removing and installing the oil filter holder with the engine oil cooler
Removing and installing the oil filter holder with the engine oil cooler
(Octavia II, Superb II, Yeti)
Special tools and workshop equipment required
t  Assembly device -T10118-
t  Catch pan, e.g. -VAS 6208-
t  Removal tool for inner lining of the door panel -MP8-602/1-
t  Old oil collecting and suction equipment, e.g. -V.A.G 1782-
t  Pliers for spring strap clamps
Removing
–  Drain coolant → Chapter.
–  Remove the air filter housing → Chapter.
   
–  Remove oil filter insert -3-:
t  → BookletOctavia II.
t  → BookletSuperb II.
t  → BookletYeti.
  N01-10738
–  Remove the charge air hose, to do so slacken the hose clamps -1- and -2-.
  A21-10489
–  Release screws -arrows-.
–  Expose coolant hose -3-.
–  Loosen hose clamp -2-.
–  Disconnect the plug -1- at the charge pressure sender -G31- with intake air temperature sender -G42- and remove the right charge air pipe.
  A21-10435
–  Slightly pull out oil dipstick, unscrew screw -1-.
–  Press off clip -2- with removal tool for inner lining of the door panel -MP8-602/1-.
–  Pull out the oil dipstick guide pipe upwards out of the cylinder block and push it to the side.
–  Position the catch pan, e.g. -VAS 6208-, under the engine.
–  Place an old oil collecting and suction equipment -V.A.G 1782- under the engine.
–  Screw out screws -arrows- and remove oil filter holder with oil cooler.
Install
l  Tightening torques: → Chapter.
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  Replace gaskets, gasket rings and O-rings.
t  Hose connections as well as charge air pipes and charge air hoses must be free of oil and grease before being installed.
t  Observe the assembly instruction for hose connections with screw clamps → Chapter.
–  Install oil filter insert, fill with engine oil and check the oil level:
t  → BookletOctavia II.
t  → BookletSuperb II.
t  → BookletYeti.
–  Top up or change coolant if the engine oil cooler was replaced → Chapter.
  A17-10509

Removing and installing engine oil cooler > < Oil filter holder - Summary of components