Octavia Mk2
| Removing and installing crankshaft |
Note| The engine should be attached to the engine repair stand with the engine holder -MP 1-202- for carrying out removal and installation work. |
| 1 - | 65 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 2 - | Bearing caps |
| q | Bearing cap 1: belt pulley side |
| q | Bearing cap 3: with recesses for thrust washers |
| q | retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another |
| 3 - | Bearing shell |
| q | for cylinder block with lubricating groove |
| q | for bearing cap without lubricating groove |
| q | do not mix up already used bearing shells (mark) |
| 4 - | Thrust washers |
| q | for bearing cap 3 |
| q | pay attention to locating element |
| 5 - | Needle bearing |
| q | only on vehicles with automatic gearbox |
| q | replace → Chapter |
| 6 - | Crankshaft |
| q | with pinion for oil pump drive |
| q | Axial play when new: 0.07…0.17 mm |
| Wear limit: 0.37 mm |
| q | Crankshaft bearing pins: Ø 54.00 mm |
| q | Conrod bearing pin: Ø 47,80 mm |
| 7 - | Bearing shell |
| q | for cylinder block with lubricating groove |
| q | for bearing cap without lubricating groove |
| q | do not mix up already used bearing shells (mark) |
