skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Piston and conrod - Summary of components > < Removing and installing crankshaft

Octavia Mk2

Replace needle bearing for crankshaft
Replace needle bearing for crankshaft
Only on vehicles equipped with automatic gearbox.
Special tools and workshop equipment required
t  Centering mandrel -T30029 (3176)-
t  Interior extractor -Kukko 21/2-
t  Countersupport -Kukko 22/1-
  Note
For installing an engine in a vehicle with automatic gearbox, check whether the needle bearing is built on the gearbox side in the crankshaft. Install the needle bearing as required.
Removing
   
–  Pull out needle bearing with interior extractor -Kukko 21/2- and countersupport -Kukko 22/1-.
Install
  V13-0903
–  Drive in the needle bearing using the centering pin -T30029-.
l  Fitting position: The marked side of the needle bearing should be legible when in its installed condition.
  S13-0332
Depth of installation of the needle bearing
l  Dimension -a- = 1.5 up to 1.8 mm
  V13-0428

Piston and conrod - Summary of components > < Removing and installing crankshaft