Octavia Mk2
Note
|
1 - | Sealing ring |
q | replace → Chapter |
q | do not oil or grease |
2 - | Sealing flange on the belt pulley side |
q | must be positioned on dowel sleeves |
q | removing and installing → Chapter |
3 - | Cylinder block |
q | removing and installing crankshaft → Chapter |
q | Disassembling and assembling pistons and conrods → Chapter |
4 - | Flywheel |
q | removing and installing → Chapter |
q | assembly is only possible in one position through offset holes |
5 - | 60 Nm + torque a further 90° (1/4 turn) |
q | replace |
6 - | Intermediate plate |
q | must be positioned on dowel sleeves |
q | do not damage/bend during assembly work |
q | hang on the sealing flange → Fig. |
7 - | 15 Nm |
8 - | Sealing flange on the gearbox side |
q | can only be replaced complete with gasket ring and with rotor of engine speed sender -G28- |
q | replace → Chapter |
9 - | Engine speed sender -G28- |
q | removing and installing → Chapter |
10 - | 5 Nm |
|