skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the sealing flange on the belt pulley side > < Removing and installing sealing flange and flywheel

Octavia Mk2

Replacing crankshaft seal on belt pulley side
Replacing crankshaft seal on belt pulley side
Special tools and workshop equipment required
t  Counterholder -T30004 (3415)- or counterholder for toothed belt sprocket -MP 1-310 (3099)-
t  Gasket ring extractor -MP 1-226 (3203)-
t  Assembly device -T10053-
Removing
l  Engine installed.
–  Removing the toothed belt:
t  Fabia II, Roomster, Rapid → Chapter.
t  Octavia II, Superb II, Yeti → Chapter.
   
–  Remove crankshaft - toothed belt sprocket, to this end lock toothed belt sprocket with counterholder -T30004- or counterholder -MP 1-310-.
  S13-0166
–  To guide the gasket ring extractor, screw the central screw for the crankshaft toothed belt sprocket into the crankshaft by hand up to the stop.
  S13-0476
–  Turn inner part of gasket ring extractor -MP 1-226- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out.
–  Clamp gasket ring extractor into the vice and remove gasket ring with pliers.
–  Clean the contact and sealing surfaces.
Install
  Note
Do not oil the sealing lip and the outer surface of the gasket ring before the pressing in procedure.
–  Remove oil residue on the crankshaft journal with a clean cloth.
  S13-0078
–  Insert guide bushing -T10053/1- on the crankshaft bearing pin.
–  Slide gasket ring over the guide bushing.
  S13-0454
–  Press in the gasket ring flush with the central screw for the crankshaft toothed belt sprocket and with the pressure bushing of the assembly device -T10053-.
  Note
t  There must not be any oil present on the contact surface between toothed belt sprocket and crankshaft.
t  Replace central screw for crankshaft toothed belt sprocket.
t  Do not oil central screw for crankshaft toothed belt sprocket.
–  Install crankshaft - toothed belt sprocket, to this end lock toothed belt sprocket with counterholder.
–  Installing the timing belt:
t  Fabia II, Roomster, Rapid → Chapter.
t  Octavia II, Superb II, Yeti → Chapter.
  S13-0455

Removing and installing the sealing flange on the belt pulley side > < Removing and installing sealing flange and flywheel