Octavia Mk2
|
| The exhaust turbocharger and the exhaust manifold are one component part. |
| 1 - | Exhaust gas turbocharger |
| q | only complete with exhaust manifold |
| q | removing and installing → Chapter |
| q | Remove and install the connection pipe for the suction hose → Chapter |
| 2 - | Vacuum setting element |
| q | with position sender for charge pressure regulator -G581- |
| 3 - | Connector |
| q | to position sender for charge pressure regulator -G581- |
| 4 - | Heat shield collar |
| q | replace if damaged |
| 5 - | Gasket |
| q | replace |
| 6 - | 20 Nm |
| 7 - | Connecting pipe |
| q | to radiator for exhaust gas recirculation |
| 8 - | Exhaust gas temperature sender 1 -G235- |
| q | Tightening torque: 45 Nm |
| q | coat thread with hot bolt paste -G 052 112 A3- before installing |
| q | removing and installing → Chapter |
| 9 - | 10 Nm |
| 10 - | Support |
| q | for oil feed line |
| 11 - | Heat shield |
| 12 - | 10 Nm |
| 13 - | Support for exhaust gas turbocharger |
| q | removing and installing → Chapter |
| 14 - | Sealing ring |
| q | replace |
| 15 - | Hollow screw, 60 Nm |
| q | replace |
| 16 - | Free position |
| 17 - | 20 Nm |
| 18 - | Hollow screw, 30 Nm |
| q | replace |
| 19 - | Sealing ring |
| q | replace |
| 20 - | Oil feed line |
| q | removing and installing → Chapter |
| q | check continuity |
| q | before installing, fill the exhaust turbocharger on the connection fitting for the oil feed line with engine oil |
| 21 - | Pulsation dampener |
| 22 - | 10 Nm |
