Octavia Mk2
| Valve gear - Summary of components |
| 1 - | 50 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 2 - | Camshaft sprocket |
| q | take note of the position when installing the timing chain |
| 3 - | 10 Nm |
| 4 - | Hall sender -G40- |
| q | with O-ring |
| q | replace the O-ring if it is damaged |
| 5 - | Cylinder head cover |
| q | removing and installing → Chapter |
| 6 - | Non-return valve |
| 7 - | 10 Nm |
| 8 - | O-ring |
| q | replace if damaged |
| q | before fitting moisten lightly with engine oil |
| 9 - | Camshaft |
| q | removing and installing → Chapter |
| q | Inspecting axial play → Chapter |
| q | moisten with oil before installing (also axial bearing collar) |
| 10 - | Valve collet |
| 11 - | Valve spring retainer |
| 12 - | Valve stem seal |
| q | replace |
| 13 - | Valve spring |
| q | with the cylinder head removed, remove and install with blank holder -3362- |
| q | (with cylinder head installed) → Chapter |
| 14 - | Valve guide |
| q | check → Chapter |
| 15 - | Cylinder head |
| q | removing and installing → Chapter |
| 16 - | Valves |
| q | do not rework, only grinding in is permissible |
| q | Valve dimensions → Fig. |
| 17 - | 15 Nm |
| 18 - | Gasket |
| q | replace |
| 19 - | Dowel pins |
| 20 - | 8 Nm |
| q | observe the order of tightening up |
| q | removing and installing → Chapter |
| 21 - | Bearing frame |
| q | for camshaft |
| q | removing and installing → Chapter |
