skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disconnect connector for accelerator pedal module and fit on > < Accelerator pedal module - Summary of components

Octavia Mk2

Removing and installing accelerator pedal module
Removing and installing accelerator pedal module
(Octavia II, Yeti)
Special tools and workshop equipment required
t  Release tool -T10238- (for left-hand drive vehicle)
t  Release tool -T10240- (for right-hand drive vehicle)
Removing
   
–  Remove steering column cover -arrows-.
–  Lever out the cap → Chapter, Pos. 4, with a screwdriver.
–  Release fixing screw → Chapter, Pos. 3.
  S20-0134
–  Push the release tool -T10238- (on right-hand drive vehicles release tool -T10240 -) as shown up to the stop into the provided openings and remove the accelerator pedal module.
–  Disconnect connector at accelerator pedal module → Chapter.
Install
  S20-0175
–  Fit the plug -2- onto the accelerator pedal module -5- → Chapter.
   The plug must lock audibly.
–  Push accelerator pedal module onto the fixing bolts -6-.
–  Insert the centering pin -7- into the hole in the underbody.
–  Fasten accelerator pedal module with screw -3- (10 Nm) and fit on cap -4-.
–  Re-install steering column cover.
–  If the accelerator pedal module was replaced, an adaptation of the engine control unit has to be performed on vehicles with automatic gearbox → Vehicle diagnostic tester.
  S20-0270

Disconnect connector for accelerator pedal module and fit on > < Accelerator pedal module - Summary of components