Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Power unit | 1,2/63; 77 kW TSI engine | Fuel supply, gas operation | Electronic Engine Power Control (Electronic throttle) | Removing and installing accelerator pedal module | Disconnect connector for accelerator pedal module and fit on

Disconnect connector for accelerator pedal module and fit on

(Octavia II, Yeti)

Note

The plugs for the accelerator pedal module which are inserted, must be disconnected and fit on in a different manner.

Disconnect connector 1K0 973 706

–	Slightly press the piston slide valve -A- (grey) in -direction of arrow 1- and push it up to the stop in -direction of arrow 2-.

–	Hold the piston slide valve in this position and disconnect the socket housing -B- towards the top in -direction of arrow 3-.

The piston slide valve -A- remains in the bottom position.

Fit on connector 1K0 973 706

–	Push the socket housing -B- down in -direction of arrow- until the housing can be heard to lock in place.

The piston slide valve -A- moves automatically upwards.

–	For safety reasons, check the connector for secure catch by tightening it in the opposite direction.

Disconnect connector 8K0 973 706

–	Pull the piston slide valve -A- (red) upwards in -direction of arrow 1- up to the stop.

–	Press the piston slide valve in -direction of arrow 2- and disconnect the socket housing -B- upwards in -direction of arrow 3-.

The piston slide valve -A- remains in the top position.

Fit on connector 8K0 973 706

–	Push the socket housing -B- downwards up to the stop in -direction of arrow 1-.

–	Slightly press the piston slide valve in -direction of arrow 2- and push it downwards in -direction of arrow 3-.

The piston slide valve -A- can only be pushed downwards if the socket housing was pushed downwards »up to the stop«.

–	For safety reasons, check the connector for secure catch by tightening it in the opposite direction.

Skoda Workshop Service and Repair Manuals