skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Exhaust system > < For vehicles manufactured up to 12.2010 (exhaust emission standard EU-4)

Octavia Mk2

For vehicles manufactured as of 01.2011 (exhaust emission standard EU-5)
For vehicles manufactured as of 01.2011 (exhaust emission standard EU-5)
  Note
t  For vehicles manufactured as of 01.2011 (exhaust emission standard EU-5), the liquefied petroleum gas control unit (LPG) is not self-diagnostic. The petrol engine control unit -J361- controls and manages all the functions of the LPG system (including the fault memory). The liquefied petroleum gas control unit (LPG) must only be activated in the „Gateway “ for the data update, afterwards the control unit must be deactivated again.
t  Observe safety measures and rules for cleanliness when working on vehicles with liquefied petroleum gas system (LPG) → Chapter.
–  Switch off ignition and withdraw ignition key.
–  Remove the sound dampening system → Body Work; Rep. gr.50.
–  Remove the left wheelhouse liner bottom part → Body Work; Rep. gr.66.
   
–  Screw out screws -arrows- and remove liquefied petroleum gas control unit from bracket.
–  Disconnect the plug -1- from the liquefied petroleum gas control unit.
Install
Installation is performed in a similar way in the reverse order. Pay attention to the following points:
–  Interrogating and erasing fault memory of engine control unit → Vehicle diagnostic tester.
–  Perform the gas system inspection (GSI) after installing the liquefied petroleum gas control unit → BookletOctavia II.
  S24-0756

Exhaust system > < For vehicles manufactured up to 12.2010 (exhaust emission standard EU-4)