Skoda Workshop Service and Repair Manuals

Removing and installing bracket for auxiliary units (Octavia II, Yeti) Special tools and workshop equipment required t  Supporting device -T30099- t  Surface -T30099/1- t  Adapter -MP9-200/3 (10-222/3)- t  Ring bolt -3368- t  Collar nut M10 Removing –  Remove alternator → Electrical System; Rep. gr.27. –  Remove the high pressure pump → Chapter.   WARNING Do not open the refrigerant circuit of the air conditioning system.   Note In order to avoid damage to the AC compressor as well as to the refrigerant lines and hoses, ensure that the lines and hoses are not over-tensioned, kinked or bent. –  Remove the AC compressor from the bracket for auxiliary units and tie up to the lock carrier. –  Remove the cooling water tank cover → Body Work; Rep. gr.66.

–  Insert the supporting device -T30099- with the base -T30099/1- and the adapter -MP9-200/3- and attach the spindle-B-.   WARNING Risk of accident due to loosened screwed connection. The collar nut must be screwed in by at least 6 turns so that the ring bolt -3368- is held securely.

–  Secure the ring bolt -3368- to the engine support with the collar nut M10 or the nut with the washer -arrow-. –  Hook spindle-A- onto ring bolt -3368-. –  Uniformly pre-tension the engine with both spindles, but do not raise.

–  Release screws -1- and -2-, remove connecting stud. –  Release screws -3...6- and remove engine mounting.

–  Release screw -3- on engine support.

–  Unscrew plug -arrow-. –  Release screws -1- and -2- and remove toothed belt camshaft drives.

–  Release screws -1…6- and remove bracket for auxiliary units. Install Installation is performed in the reverse order, pay attention to the following points:   Note Replace screws which have been tightened to a torquing angle. –  If no dowel sleeves are present on the top right between the bracket for auxiliary units and the cylinder block, insert dowel sleeves. –  Tighten the screws for the bracket for auxiliary units → Fig.. –  Install engine support and engine mount → Chapter. –  Install high pressure pump → Chapter. –  Installing the timing belt → Chapter. –  Install alternator → Electrical System; Rep. gr.27. –  Install AC compressor at the bracket for auxiliary units → Chapter.