skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing toothed belt > < Removing and installing bracket for auxiliary units

Octavia Mk2

Timing belt drive - Summary of components
   
Timing belt drive - Summary of components
1 - Toothed belt
q   before removing mark running direction
q   check for wear
q   do not kink
q   removing and installing → Chapter
  Note
If the toothed belt is replaced when carrying out engine repair (apart from regular change interval), it should be entered in the → Service Schedule!
2 - 20 Nm
3 - Guide pulley
4 - 50 Nm + torque a further 90° (1/4 turn)
q   replace
5 - 20 Nm + torque a further 45° (1/8 turn)
6 - Tensioning pulley
q   for removing and installing, remove engine support:
t  Octavia II, Yeti → Chapter
t  Superb II → Chapter
7 - 20 Nm + torque a further 45° (1/8 turn)
q   replace
8 - Camshaft sprocket
9 - Guide pulley
10 - 20 Nm
11 - 100 Nm
q   to release and tighten use counterholder -T10051-
12 - Hub
q   for camshaft
q   with rotor
q   to remove use extractor -T10052-
q   removing and installing → Chapter
13 - 9 Nm
14 - Rear toothed belt guard
15 - 20 Nm + torque a further 45° (1/8 turn)
q   replace
q   Attach high pressure pump
16 - 9 Nm
17 - Guide pulley
18 - Hub
q   for high pressure pump
q   to release and tighten use counterholder -T10051-
q   to remove use extractor -T40064-
q   removing and installing → Chapter
19 - 95 Nm
20 - Toothed belt gear on the high pressure pump
21 - Timing belt guard - top part
22 - 20 Nm + torque a further 90° (1/4 turn)
q   replace
23 - Coolant pump
q   removing and installing → Chapter
24 - 15 Nm
25 - Crankshaft - toothed belt sprocket
26 - 120 Nm + torque a further 90° (1/4 turn)
q   replace
q   to release and tighten use counterholder -T30004 (3415)-
q   Neither oil nor grease thread or collar.
q   tightening may occur in successive stages
27 - Timing belt guard - bottom part
28 - Timing belt guard - middle part
29 - 9 Nm
q   apply locking agent -D 000 600 A2- before installing
30 - Crankshaft-belt pulley
q   with vibration damper
31 - 10 Nm + torque a further 90° (1/4 turn)
q   replace

   

Removing and installing toothed belt > < Removing and installing bracket for auxiliary units