skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the microphone for the telephoneR38 > < Removing and installing the control unit for the mobile phone operating electronicsJ412 (up to CW 44.08)

Octavia Mk2

Removing and installing the control unit for the mobile phone operating electronicsJ412 (as of CW 45.08)
Removing and installing the control unit for the mobile phone operating electronics -J412- (as of CW 45.08)
  Note
The control unit for the mobile phone operating electronics -J412- cannot be exchanged with the control units mounted up to CW 44.08 (old dash panel insert) see → Electronic Catalogue of Original Parts.
The control unit for the mobile phone operating electronics -J412- is located below the right front seat.
Removing
–  Switch off all electrical components and take out the ignition key.
–  Push the right front seat completely towards the rear and the highest point.
   
–  Slightly raise the edges of the cover -arrows A- and pull out the cover -arrow B-.
GSM II up to CW 21.10
  S91-0181
–  Release screw -4- (6 Nm).
–  Slightly raise the bracket for the control unit -5--arrow A- and pull out the control unit -3--arrow B-.
–  Unlock by tilting out the clamp -2- and disconnect the plug connection -1-.
GSM II as of CW 22.10 and GSM III
  S91-0183
–  Release screws -arrows- (3 Nm).
  N91-10673
–  Press the catch -A- and disconnect the plug connection by tilting out the clamp -arrow B-.
–  Unlock the plug of the aerial cable -arrows- and detach.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  When replacing, code the new control unit after the installation → Vehicle diagnostic tester
  N91-10674

Removing and installing the microphone for the telephoneR38 > < Removing and installing the control unit for the mobile phone operating electronicsJ412 (up to CW 44.08)