skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the control unit for the mobile phone operating electronicsJ412 (as of CW 45.08) > < Removing and installing the mount for the mobile phone

Octavia Mk2

Removing and installing the control unit for the mobile phone operating electronicsJ412 (up to CW 44.08)
Removing and installing the control unit for the mobile phone operating electronics -J412- (up to CW 44.08)
  Note
The control unit for the mobile phone operating electronics -J412- cannot be exchanged with the control units mounted as of CW 45.08 (new dash panel insert) see → Electronic Catalogue of Original Parts.
Removing
Left-hand drive vehicles:
–  Remove front passenger seat → Body Work; Rep. gr.72.
Right-hand drive vehicles:
–  Remove the driver's seat → Body Work; Rep. gr.72.
Continued for all vehicles:
   
–  Unclip clips -arrows-.
–  Remove cover of control unit -1-.
–  Unplug connector -2-.
–  Release screws -A- (1.7 Nm).
–  Disconnect aerial for bluetooth -3- (if present).
–  Remove the control unit holder from the vehicle.
–  Remove the control unit from the holder in -direction of arrow-.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  When replacing, code the new control unit after the installation → Vehicle diagnostic tester
  S91-0127

Removing and installing the control unit for the mobile phone operating electronicsJ412 (as of CW 45.08) > < Removing and installing the mount for the mobile phone