skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the relay carrier under the vehicle voltage control unitJ519 - vehicles as of MY 09 > < Fuse holder and relay carrier

Octavia Mk2

Removing and installing fuse holder from dash panel
Removing and installing fuse holder from dash panel
Removing
–  Disconnect battery earth strap → Chapter.
   
–  Insert the screwdriver in the recess -2-, lever out the side cover -1--arrow- and remove from the dash panel.
–  Remove lower part of the dash panel insert on the driver's side → Body Work; Rep. gr.70.
  N97-10076
–  Release both fixing screws (2 Nm) -arrows- and take out the fuse holder -A- towards the inside.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Pay attention to the work sequence when connecting the battery → Chapter.
  S97-3705

Removing and installing the relay carrier under the vehicle voltage control unitJ519 - vehicles as of MY 09 > < Fuse holder and relay carrier