skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing additional relay carrier above the onboard supply control unit > < Removing and installing fuse holder from dash panel

Octavia Mk2

Removing and installing the relay carrier under the vehicle voltage control unitJ519 - vehicles as of MY 09
Removing and installing the relay carrier under the vehicle voltage control unit -J519- - vehicles as of MY 09
  Note
t  The assignment of the relay carrier depends upon the vehicle equipment.
t  Exact assignment of the relay carrier → Current flow diagrams, Electrical fault finding and Fitting locations.
Removing
–  Disconnect battery earth strap → Chapter.
–  Remove lower part of the dash panel insert on the driver's side → Body Work; Rep. gr.70.
   
–  Press together the catch pegs -arrows A- and push the relay carrier -1- with relays out of the brackets at the vehicle voltage control unit -2-.
–  Take the relay out of the relay carrier.
  S97-6346
–  Press off the catch pegs -arrows- and press the plug connections out of the relay carrier.
Install
Installation is performed in the reverse order, pay attention to the following points:
–  Pay attention to the work sequence when connecting the battery → Chapter.
  S97-6347

Removing and installing additional relay carrier above the onboard supply control unit > < Removing and installing fuse holder from dash panel