skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Repairing corrugated washer fluid level pipes - vehicles as of 01.2011 > < Repair solution for corrugated pipe

Octavia Mk2

Repairing corrugated washer fluid level pipes - vehicles up to 12.2010
Repairing corrugated washer fluid level pipes - vehicles up to 12.2010
  Note
t  When changing the material of the corrugated pipe, the following procedure cannot be applied to vehicles manufactured as of 01.2011 (this would result in a leaky connection point).
t  The other described procedure ( → Chapter) can also be applied to vehicles manufactured up to 01.2011.
   
Summary of components of connecting piece
1 - Catch clamp
2 - Connecting piece
3 - Tensioning ring
4 - O-ring
5 - O-ring
6 - Corrugated pipe
Method:
  S92-0091
–  Cut the damaged point straight out of the corrugated pipe to be repaired so that the distance between the pipe ends is maximum 20 mm.
  Note
t  If the damaged point is longer than 20 mm, insert new corrugated pipe and then perform the described work sequence twice.
t  The repair point must not be exposed to tension or flexion.
–  Push tensioning rings -2- onto the ends of the pipes -1- in such a way that two shafts of the pipe protude.
–  Then push O-rings -3- onto the ends of the pipe. One shaft of the pipe protrudes.
–  Fit pipes with tensioning rings onto the connecting pieces -4- and -5--arrows A-.
  S92-0092
–  Compress connecting pieces -4- and -5--arrows B-.
–  Perform a functional and tightness test.
  S92-0093

Repairing corrugated washer fluid level pipes - vehicles as of 01.2011 > < Repair solution for corrugated pipe