Roomster
| Setting overview |
Note| t | When working on the gearbox it is only necessary to re-set the drive shaft, output shaft or differential gear if parts were replaced that directly affect the setting of the gearbox. |
| t | To avoid unnecessary settings, refer to the following table: |
| Set: | ||||
| Drive shaft | Output shaft | Differential gear | ||
| → Chapter | → Chapter | → Chapter | ||
| Replaced part: | Gearbox housing | x | x | |
| Clutch housing | x | x | x | |
| Drive shaft | x | |||
| Output shaft | x | |||
| Differential gear housing | x | |||
| Tapered-roller bearing for drive shaft | x | |||
| Tapered-roller bearing for output shaft | x | |||
| Tapered-roller bearings for differential gears. | x | |||
| 4th gear pinion | x | |||