–
| Cut off nozzle tube at the front marking (Ø of nozzle approx. 3 mm). |
–
| Apply silicone sealant to the clean sealing surface of the sealing flange, as shown in the illustration. Sealant bead must: |
t
| Thickness of sealant bead -arrows-: 2 ... 3 mm |
Note t
| Before applying the sealant bead cover over the gasket ring with a clean cloth. |
t
| The sealant bead must not be thicker otherwise excess sealant may get into the oil pan and block the strainer in the oil suction pipe. |
t
| Pay attention to the 'use by date' on sealant. |
t
| The sealing flange must be installed within 5 minutes after applying the silicone sealant. |
t
| When installing the sealing flange with the gasket ring fitted use guide sleeve -T 10053/1-. |
t
| After installing, allow the sealant to dry for about 30 minutes. Only then may engine oil be filled in. |
–
| Fit sealing flange immediately and lightly tighten all bolts. |
–
| Tighten the fixing screws of the sealing flange crosswise. Tightening torque: 15 Nm |
|
|
|