Skoda Workshop Service and Repair Manuals > Superb > Drive unit | 1.9/74; 1.9/77 kW TDI engine | Engine cooling | Removing and installing parts of the cooling system

Removing and installing coolant pump

Special tools and workshop equipment required

t	Catch pan, e.g. - VAS 6208-

t	Pliers for spring strap clamps

Removing

Note

Always replace seals and gasket rings.

–	Put lock carrier in service position → Body Work → Rep. Gr.50.

–	Drain coolant → Chapter.

–	Removing timing belt → Chapter.

–	Unscrew the fixing screws -1- of the coolant pump -2- and carefully remove the coolant pump.

Install

Installation is performed in the reverse order, pay attention to the following points:

–	Moisten new O-ring -3- with coolant.

–	Position the coolant pump -2- in the cylinder block and tighten the fixing screws -1-. Tightening torque: 15 Nm.

Note

The plug of the coolant pump points downwards.

–	Install timing belt and tension → Chapter.

–	Top up coolant → Chapter.

Skoda Workshop Service and Repair Manuals