skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Hose connections > < Charge air system with exhaust gas turbocharger

Superb

Assembly of hose connections with push-fit couplings
Assembly of hose connections with push-fit couplings
  Caution
The gasket ring for the push-fit coupling can be damaged, if the locking clip is in the lock position during the assembly. There would be a leak in the connection. Observe the assembly instruction.
  Note
All the hose connections of the charge air system are secured with spring strap clamps or push-fit couplings. For the push-fit couplings pay attention to the following points:
Removing
   
–  Release push-fit coupling by pulling the locking clip -arrow-. Disconnect hose/pipe without auxiliary tool.
Install
–  Observe that the retaining lugs latch when installing -A-.
–  When replacing the gasket ring, place the gasket ring in the groove of the charge air hose. Make sure that the gasket ring if fully seated all round in the groove.
–  Oil sealing surface and gasket ring.
  N21-0184
–  Put the locking clip into the release position -1-.
–  Insert the charge air hose up to the stop into the coupling.
–  Put the locking clip into the lock position -2- and then press down once again the charge air hose.
–  Check hose for tight connection by pulling on it and check the correct locking of the push-fit coupling.
  N21-10133

Hose connections > < Charge air system with exhaust gas turbocharger