skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Crankshaft, Piston and Conrod > < Removing and installing V-ribbed belt

Superb

Replacing gasket ring for crankshaft -on the belt pulley side-
Replacing gasket ring for crankshaft -on the belt pulley side-
Special tools and workshop equipment required
t  Counterholder -T30004- or -MP 1-310-
t  Gasket ring extractor -MP 1-226-
t  Assembly device -T10053 -
t  Torque wrench
Removing
–  Removing timing belt → Chapter.
   
–  Remove crankshaft toothed belt sprocket. To this end lock the timing belt gear with counterholder.
  Note
When screwing on the counterholder place 2 washers between the crankshaft timing belt gear and the counterholder.
–  To guide the gasket ring extractor, screw central bolt by hand fully into the crankshaft.
–  Unscrew inner part of the gasket ring extractor -MP 1-226- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
  S13-0166
–  Oil the thread head of the gasket ring extractor, position and forcefully screw into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out.
Install
–  Remove oil residue on the crankshaft stub with a clean cloth.
  S13-0078
–  Install -T10053/1- guide bushing on the crankshaft stub.
–  Slide gasket ring over the guide bushing onto the crankshaft stub.
  S13-0454
–  Press in the gasket ring with central screw and pressure bushing - T10053- up to the stop.
–  Install and tension timing belt → Chapter.
  S13-0455

Crankshaft, Piston and Conrod > < Removing and installing V-ribbed belt