skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling engine > < Removing and installing timing belt

Superb

Removing and installing V-ribbed belt
   
Removing and installing V-ribbed belt
1 - 25 Nm
2 - AC generator
3 - 25 Nm
4 - Reversing lever
q   for the tensioning roller
5 - Spacer
q   pay attention to correct installation position
6 - Tensioning pulley
q   for the V-ribbed belt
7 - Tensioning element
q   for the V-ribbed belt
8 - Compact holder
q   for the alternator, clamping element for V-ribbed belts, the viscous fan coupling and vane pump for the power-assisted steering.
q   with bearing bush for fan
q   removing and installing bearing bush → Chapter
9 - 45 Nm
q   observe the order of tightening up → Chapter
10 - 45 Nm
11 - Vane pump
q   for power-assisted steering
12 - Hollow screw - 50 Nm
13 - Gasket ring
q   replace
14 - Pressure line
15 - Belt pulley
q   for vane pump
16 - Bracket
q   for the clamping element
17 - Belt pulley
q   for the visco fan coupling
18 - Visco fan coupling
q   removing and installing → Chapter
19 - 10 Nm

Removing and installing V-ribbed belt
  Note
Mark the direction of rotation with chalk or a felt-tip pen before removing the V-ribbed belt. Reversing the rotation direction of an already used belt may destroy it rapidly.
Removing
–  Put lock carrier in service position → Body Work; Rep. Gr.50.
–  Mark the rotation direction of the V-ribbed belt.
–  Remove V-ribbed belt for AC compressor → Heating, Air Conditioning; Rep. Gr.87.
   
–  Turn the tensioning pulley with a wrench in the -direction of the arrow-.
–  First of all take V-ribbed belt off generator belt pulley and then from the other belt pulleys.
Install
Installation occurs in reverse order to removal.
  Note
Pay attention to the correct position of the V-ribbed belt in the belt pulley when installing it.
–  Check ribbed V-belt run with the engine running.
  S13-0446

Disassembling and assembling engine > < Removing and installing timing belt