| The arrows in the figures point to the front. |
| –
| Push the middle silencer forward until the dimension -a- 5...9 mm is obtained on the suspension/middle silencer (right half of image). |
| –
| Tighten screws of clamping sleeve in front of middle silencer. |
| –
| Push the rear silencer forward until the dimension -a- 7...11 mm is obtained on the suspension behind the rear silencer (left half of image). |
| –
| Check alignment of exhaust tail pipes to body and tighten screws of clamping sleeve between middle and rear silencer. |
|
|
|
