Superb
| Summary of components - Foot controls (right-hand drive vehicles) |
| 1 - | Bracket |
| q | with bearing bush for the clutch and brake pedals |
| q | before removing, detach steering column from steering gear → Chassis; Rep. Gr.48 |
| q | removing and installing → Chassis; Rep. Gr.46 |
| 2 - | Washer |
| 3 - | Brake pedal |
| q | the stud only fits in one position in the bushing Pos. 9 |
| q | Assignment → Electronic Catalogue of Original Parts |
| 4 - | turn 30 Nm and 180° |
| q | is fitted, if there is no threaded bore for the screw Pos. 13 in the stud of the brake pedal |
| q | Assignment → Electronic Catalogue of Original Parts |
| 5 - | 23 Nm |
| 6 - | Master cylinder |
| q | after removing, do not operate the clutch pedal |
| q | Gasket -arrow- must not be removed |
| 7 - | 20 Nm |
| 8 - | Clutch pedal |
| q | can only be removed in the unmounted condition of the foot controls → Chassis; Rep. Gr.46 |
| 9 - | Bushing |
| q | check for ease of movement in the clutch pedal |
| 10 - | Bearings |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | insert in the bracket with the over dead-centre spring. |
| q | Fitting position: the deep recess faces downwards. |
| 11 - | Over-centre helper spring |
| q | Assignment → Electronic Catalogue of Original Parts |
| 12 - | Clutch pedal switch -F 36- |
| q | removing and installing, setting → Chapter |
| q | may only be installed once |
| 13 - | 25 Nm |
| q | for version with nut Pos. 4 (no threaded bore is fitted in the brake pedal) tighten the nut to specified tightening torque Pos. 4 |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| 14 - | Lever |
| q | the stud only fits in one position in the bushing Pos. 9 |
| 15 - | 25 Nm |
| q | serves, at the same time, to secure the brake master cylinder with the brake servo unit to the bracket |
| 16 - | 25 Nm |