Yeti
| Assembly overview of covers and upholstery for seat |
| 1 - | Cover |
| Removing: |
| – | Removing backrest → Chapter. |
| – | Detach clamping section -3- from seat rack -6-. |
| – | Unhook tensioning elastics. |
| – | Cut through clips -7-. |
| – | Remove cover from seat. |
| Installing: |
Note| When installing the cover, use upholstery clip pliers e.g. -V.A.G 1634-. |
| – | Installation is carried out in the reverse order. |
| 2 - | Strut |
| q | Sewn to cover |
| q | With holes. |
| 3 - | Clamping section |
| 4 - | Connector for heating element |
| q | If present. |
| 5 - | Seat foam padding |
| Removing: |
| – | Remove seat cover (Pos. 1). |
| – | Remove foam padding. |
| Installing: |
| – | Installation is carried out in the reverse order. |
| 6 - | Seat rack |
| 7 - | Clamp |
| q | When removing cut through with pliers |
| q | When installing, replace with new original parts. |
| q | To install use upholstery pliers, e.g. -V.A.G 1634-. |
| 8 - | Heating element |
| q | If present. |