Yeti
Removing and installing the central pipe |
1 - | Central pipe |
Removing: |
– | Removing dash panel → Chapter. |
– | Remove fuse holder from central pipe → Electrical System; Rep. gr.97. |
– | Unhook relay carrier from central pipe → Electrical System; Rep. gr.97. |
– | Remove knee airbag → Chapter. |
– | Remove crash strut for clutch pedal -8-. |
– | Remove the steering column assembly from the central pipe → Chassis; Rep. gr.48. |
– | Remove the intermediate piece for the dash panel vent → Heating and Air Conditioning; Rep. gr.87. |
– | Remove the intermediate piece for the defroster duct → Heating and Air Conditioning; Rep. gr.87. |
– | Remove the screws -2- of the console -3- and the tunnel struts. |
– | Partially remove windscreen wiper motor → Electrical System; Rep. gr.92. |
– | Remove the screw -10- from the water channel. |
– | Remove the nuts -11- and loosen the electric installation with the heater mounting brackets. |
– | Remove the nuts -9- and take out the central pipe -1-. |
Installing: |
– | Installation is carried out in the reverse order. |
2 - | 2 Nm |
3 - | 20 Nm |
4 - | Console |
5 - | Holder for knee airbag |
Removing: |
– | Remove knee airbag → Chapter. |
– | Remove the screws -6- and take out the holder. |
Installing: |
– | Installation is carried out in the reverse order. |
6 - | 9 Nm |
7 - | Crash strut for brake pedal |
Removing: |
– | Remove holder for knee airbag -5-. |
– | Remove screws -6- and remove strut. |
Installing: |
– | Installation is carried out in the reverse order. |
8 - | Crash strut for clutch pedal |
Removing: |
– | Remove holder for knee airbag -5-. |
– | Remove screws -6- and remove strut. |
Installing: |
– | Installation is carried out in the reverse order. |
9 - | Nut, 20 Nm |
10 - | 25 Nm |
11 - | Nut, 9 Nm |