skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Brake pedal - Vehicles with right-hand drive > < Repairing rear brake

Yeti

Separating the brake pedal from the brake servo unit and clipping onto brake servo unit
Separating the brake pedal from the brake servo unit and clipping onto brake servo unit
Special tools and workshop equipment required
t  Release tool -T10159A-
Removing:
–  Removing driver side trim panel → Body Work; Rep. gr.70.
   
–  Press the brake pedal towards the brake servo unit and hold it in position.
2 - Pressure rod
3 - Retaining lugs
–  Insert release tool -T10159A- and pull it in the direction of the driver's seat while counterholding the brake pedal (the pedal must not move backwards during this operation). This causes the retaining lugs -3- of the support to be pressed off the spherical head of the push rod -2-.
Fig. shows the separation of the brake pedal from the brake servo unit with the foot controls removed for clarity.
–  Now pull the release tool -T10159A- and the brake pedal jointly towards the driver's seat. (This causes the brake pedal to be drawn off the ball knob of the pressure rod).
Installing:
Clip the brake pedal onto the brake servo unit.
  S46-0178
–  Hold the ball knob of the pressure rod against the support in the brake pedal and press the brake pedal in the direction of the arrow towards the brake servo unit so that the ball knob is heard to click into the support.
Further installation occurs in reverse order.
  S46-0028

Brake pedal - Vehicles with right-hand drive > < Repairing rear brake