Yeti
| Disassembling and assembling the air conditioning unit (Climatic, air conditioning system with manual control) |
| 1 - | Control motor for temperature flap -V68- |
| q | removing and installing → Chapter |
| 2 - | Support |
| 3 - | Cover |
| 4 - | Re-circulating air flap control motor -V113- |
| q | removing and installing → Chapter |
| 5 - | Housing for air inlet |
| q | with re-circulating air flap |
| 6 - | Housing - top part |
| 7 - | Housing - bottom part |
| 8 - | Evaporator |
| q | removing and installing → Chapter |
| 9 - | Hose for glove compartment cooling |
| q | no longer fitted as of CW 46.2010 |
| 10 - | Series resistor for fresh air blower with overheating fuse -N24- |
| q | removing and installing → Chapter |
| 11 - | Fresh air blower -V2- |
| q | removing and installing → Chapter |
| 12 - | Dust and pollen filter |
| q | Also filter version with odour insert, see → Catalogue of Original Parts |
| q | removing and installing → Chapter |
| 13 - | Cover |
| q | for dust and pollen filter |
| 14 - | Heat exchanger |
| q | removing and installing → Chapter |
| 15 - | Heat exchanger trim panel |
| 16 - | Heating element for air auxiliary heating -Z35- |
| q | only fitted on certain models |
| q | removing and installing → Chapter |
| 17 - | Distributor housing |
| 18 - | Positioning motor of front air distribution -V145- |
| q | the removal and installation is the same for the front air distribution flap control motor -V426- → Chapter |