skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the middle vent temperature senderG191 > < Right-hand drive

Yeti

Removing and installing the Footwell vent temperature senderG192
Removing and installing the Footwell vent temperature sender -G192-
  Note
Is not mounted as of CW 46.2010.
Removing
–  Switch off the ignition and all electrical components.
–  Removing dash panel insert → Electrical System; Rep. gr.90.
   
–  Rotate sender -2- by 90° and take out.
–  Disconnect plug connection -1-.
Install
Installation is carried out in the reverse order.
When installing, pay attention to the correct seating of the gasket ring -3-.
  S87-0235

Removing and installing the middle vent temperature senderG191 > < Right-hand drive