skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Gearbox mechanics,operation, construction,diff. > < Repairing clutch

Yeti

Bleed the clutch control
Bleed the clutch control
Special tools and workshop equipment required
t  Brake filling and bleeding device (e.g. -VAS 5234- or -ROMESS-
  Note
t  When performing the following work, make sure that no brake fluid comes into contact with the frame side rail or the gearbox.
t  A pre-filling of the system is not necessary!
Brake fluid specification → Chassis; Rep. gr.00.
–  Remove air filter → Engine; Rep. gr.23.
–  Connect the brake filling and bleeding device.
To bleed use bleeder hose.
–  Connect the ventilation hose with the drip bottle of the brake bleeding device.
   
–  Fit the bleeder hose onto the vent valve -arrow-.
–  Activate system with a pressure of 0.2 MPa.
–  Open vent valve.
  Note
On certain vehicles the vent valve can be opened by hand. To do so, turn the vent valve 180° to the left as far as the stop.
–  Allow approx. 100 cm3 of brake fluid to flow out.
–  Close vent valve.
–  Activate pedal forcefully from stop to stop between 10 and 15 times.
–  Activate system with a pressure of 0.2 MPa.
–  Open vent valve.
–  Allow approx. 50 cm3 more brake fluid to flow out.
–  Close vent valve.
–  After completing the bleeding procedure activate the clutch pedal repeatedly.
–  If necessary, bleed the clutch control once again → Chapter.
–  Install air filter → Engine; Rep. gr.23.
  S30-0146

Gearbox mechanics,operation, construction,diff. > < Repairing clutch