Yeti
Note| Always replace the needle bushing from the clutch housing or from the reverse shaft support after disassembling → Electronic Catalogue of Original Parts. |
| 1 - | Clutch housing |
| 2 - | Needle bushing |
| q | removing → Fig. |
| q | installing → Fig. |
| q | always replace after removing → Electronic Catalogue of Original Parts |
| 3 - | Reverse pinion |
| 4 - | Circlip |
| q | always replace after removing → Electronic Catalogue of Original Parts |
| q | carefully fit on new circlip |
| q | do not over-extend |
| 5 - | Reverse gear sliding gear |
| q | remove circlip Pos. 4 before replacing |
| q | collar points to reverse gear pinion |
| 6 - | Reverse shaft |
| q | removing and installing → Chapter |
| 7 - | Needle bushing |
| q | pressing out → Fig. |
| q | installing → Fig. |
| q | always replace after removing → Electronic Catalogue of Original Parts |
| 8 - | reverse shaft support |
| q | removing and installing → Chapter |
Note
|
|
|
|
|
|
|
|
