skoda Workshop Repair Guides

Skoda Yeti Repair Manuals and Service Guides

ABOUT US
Removing and installing the gearbox > < Electric/electronic components and fitting locations of the automatic gearbox DSG - 0AM

Yeti Power Transmission: Gearbox 0AM-DSG Shift Mechanism

Adjusting selector lever control cable
Adjusting selector lever control cable
The selector lever control cable must always be set, if:
t  the selector lever control cable was removed from the gearbox.
t  Remove and install engine and (or) gearbox.
t  Removed and installed parts of the unit mounting.
t  the selector lever control cable or the shift mechanism was removed and installed.
t  the position of the engine/gearbox was changed, e.g. during a stress-free assembly.
–  Remove air filter → Engine; Rep. gr.24 or → Engine; Rep. gr.23.
   
–  Check if the lock washer -arrow- is correctly fitted and secured towards the bottom.
  Note
The lock washer -arrow- must be replaced after each removal → Electronic Catalogue of Original Parts.
–  Shift selector lever from „P“ to „S“.
–  Check the protective cover at the front gearshift mechanism on the selector lever control cable for damage. The selector lever control cable must be replaced if damaged.
l  Gearshift mechanism and selector lever control cable must move smoothly when shifting gears. If this is not the case, replace the selector lever control cable or repair the gearshift mechanism:
t  Octavia II, Superb II, Yeti „old shifting“ → Chapter
t  Octavia II, Superb II, Yeti „new shifting“ → Chapter
t  Fabia II, Roomster → Chapter
Setting
–  Shift selector lever in the vehicle into position „P“.
–  Switch off ignition.
  N34-11375
–  Release screw -arrow-.
  Note
If the clamping screw -arrow- is released, the selector lever of the gearshift mechanism must remain in position „P“, otherwise the setting is not correct.
  N34-11376
–  Position gearshift lever at gearbox in „P“. To do so, press the gearshift lever in -direction of arrow- in the direction towards the cable support.
  N34-11377
The figure shows the gearbox »from the rear«. -P- is in the direction towards the cable support.
–  Turn both front wheels in one direction, e.g. by rolling the vehicle forwards, until the parking lock in the gearbox engages into the parking gear.
l  Only if both front wheels cannot be simultaneously turned in one direction, the parking lock is engaged.
–  Slightly move the selector lever towards the front and rear, without shifting into another selector lever position.
  Note
The selector lever control cable is therefore released.
  N34-11372
–  Tighten screw -arrow- at selector lever cable without jolting to tightening torque.
Vehicles Octavia II, Superb II and Yeti
Tightening torques:
t  up to 11.08 tightening torque 13 Nm
t  as of 12.08 tightening torque 12 Nm
Vehicles Fabia II and Roomster
Tightening torque: 12 Nm
Continued for all vehicles
  Note
Pay attention when tightening the screw -arrow- that the selector lever control cable no longer shifts.
–  Install air filter → Engine; Rep. gr.24 or → Engine; Rep. gr.23.
  N34-11376

Removing and installing the gearbox > < Electric/electronic components and fitting locations of the automatic gearbox DSG - 0AM