skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing fuel gauge sender -2-G169 > < Check fuel flow rate

Yeti

Check power consumption
Check power consumption
–  Fold up the rear seat bench with brackets.
–  Remove floor covering under the rear seat bench.
   
–  Unclip the cover -4- with the fuel pump control unit -J538--1-.
  S20-0159
–  Connect the current probe -A- of the vehicle diagnosis, measurement and information system -VAS 5051- on the line -B- to contact 1 of the 5-pin plug.
–  Start engine and run in idle.
–  Measure power consumption of the fuel delivery unit.
   Specified value: max. 9 A
  Note
If the fault in the fuel supply system is intermittent then tests can be undertaken during a test drive but then two people are required for this.
If the specfied current uptake is exceeded:
–  Fuel pump defective, replace the fuel delivery unit → Chapter.
  S20-0269

Removing and installing fuel gauge sender -2-G169 > < Check fuel flow rate