–
| Remove the plug connection -2- for the hall sender -G40- from the bracket and disconnect. |
–
| Remove the bracket from the coolant pipe. |
–
| Remove the coolant hoses, to do so slacken the spring strap clamps -1- and -3-. |
–
| Unscrew screws -arrows- and detach the front coolant pipe from the cylinder block to the left. |
Installation is performed in the reverse order, pay attention to the following points: |
Note t
| Replace gaskets, gasket rings and O-rings. |
–
| Clean sealing surface for O-ring or smoothen. |
–
| Moisten O-ring with coolant and fit onto front coolant pipe. |
–
| Slide the front coolant pipe into the cylinder block. |
–
| Install exhaust gas recirculation pipe → Chapter. |
–
| Install the left charge air pipe → Chapter. |
–
| Install the throttle valve control unit -J338- → Chapter. |
|
|
|