skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Radiator and radiator fan > < Removing and installing parts of the lubrication system

Yeti

Removing and installing coolant pump
Removing and installing coolant pump
Removing
–  Drain coolant → Chapter.
–  Removing toothed belt → Chapter.
   
–  Release screws -1- and remove coolant pump -2-.
–  Remove O-ring -3-.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
Replace O-ring.
–  Clean sealing surface for O-ring or smoothen.
  S19-0163
–  Moisten new O-ring -3- with coolant.
–  Attach the coolant pump -2-.
l  Fitting position: Plug in housing points down.
–  Tighten screws -1- of coolant pump to 15 Nm.
–  Installing the timing belt → Chapter.
–  Top up coolant → Chapter.
  S19-0163

Radiator and radiator fan > < Removing and installing parts of the lubrication system