Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Cooling system >
< Coolant pump and coolant regulator
Yeti
Power unit
2.0/103; 125 kW TDI CR Engine (1st generation)
Engine cooling
Radiator and radiator fan
Removing and installing radiator
Removing and installing radiator
Special tools and workshop equipment required
t
Catch pan, e.g. -VAS 6208-
t
Pliers for spring strap clamps
Removing
–
Drain coolant
→ Chapter
.
–
Pull off left coolant hose from radiator
-arrow-
.
–
Remove fan shroud with radiator fans
→ Chapter
.
On vehicles with air conditioning
–
Disconnect plug
-A-
on the high pressure sender -G65-
-B-
.
Continued for all vehicles
–
Remove cover for connection fitting, to do so release lateral retaining clasps
-arrows-
.
–
Release screws
-arrows-
for connection fitting
-1-
and take connecting hose
-2-
out of the guide.
–
Press in pegs
-1-
and
-3-
and pull off connecting hose
-4-
from air filter housing
-2-
.
–
Screw out screws
-arrows-
and remove the radiator upwards.
Install
Installation is performed in the reverse order, pay attention to the following points:
Note
t
Replace gasket rings and O-rings.
t
Secure all hose connections with corresponding hose clips.
–
Top up coolant
→ Chapter
.
Power unit
2.0/103; 125 kW TDI CR Engine (1st generation)
Engine cooling
Radiator and radiator fan
Cooling system >
< Coolant pump and coolant regulator