4 Runner 2WD L4-2693cc 2.7L DOHC MFI (1997)
2. Using the 09950-00020 SST, a brass bar and press, remove the bearing.
e. Install a new intermediate shaft No.2 bearing.
1.
Using the 09309 - 37010 SST and a press, install a new bearing.
2. Using a snap ring expander, install the snap ring.
f.
Install the intermediate shaft No.2
1. Install the shaft into the differential tube.
2. Using needle nose pliers, install the snap ring.
g. Install a new oil seal.
1. Using the 09223-15020 SST and a plastic hammer, install a new oil seal. The oil seal drive in depth should be 5.5 mm (0.217 inch).
2. Coat the oil seal lip with MP grease.
h. If the vehicle came w/ A.D.D., install the clutch hub, doing the following.
1. Install the clutch hub to the intermediate shaft No.2.
2. Using snap ring pliers, install the snap ring.
3. Replace the A.D.D. actuator, if necessary by performing these procedures.
a. Remove the A.D.D. switch.
