Camry Wagon L4-2.0L (3S-FE) (1990)
5. ASSEMBLE INBOARD JOINT
(a) Pack in grease to the inboard joint tulip.
HINT: Use the grease supplied in the boot kit.
Grease capacity:
TOYOTA Type:
M/T 232 g (0.51 lb)
A/T 180 g (0.40 lb)
Grease color: Yellow ocher
(b) Align matchmarks drive shaft and inboard joint tulip.
6. PACK IN GREASE TO OUTBOARD JOINT
(a) Pack in grease to the outboard joint.
HINT: Use the grease supplied in the boot kit.
Grease capacity:
TOYOTA Type: 120 g (0.26 lb)
GKN Type: 80 - 100 g (0.18-0.22 lb)
Grease color: Black
7-1.
(TOYOTA TYPE)
INSTALL BOOT CLAMPS TO BOTH BOOT
(a) Be sure the boot is on the shaft groove.
(b) Bend the band and lock it as shown.
(c) Insure that the boot is not stretched or contracted when the drive shaft is at standard length.
Drive shaft length:
LH 558.7 ± 5.0 mm (21.996 ± 0.197 in.)
RH 845.2 ± 5.0 mm (33.276 ± 0.197 in.)