Highlander 2WD V6-3.3L (3MZ-FE) Hybrid (2006)
a. After connecting the connector, press the lever down to connect the No.3 wire frame and install the bolt to the w/ converter inverter
assembly.
Torque:10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the No.3 wire frame (high voltage cable of the rear motor) with the 5 bolts to the w/ converter inverter assembly. (for 4WD)
Torque:10 N.m (102 kgf.cm, 7 ft.lbf)
6. CONNECT MG ECU CONNECTOR
CAUTION: Wear insulating gloves.
NOTE:
-
Make sure that the inverter converter is temporarily installed before working on the converter inverter assembly.
-
Do not allow any foreign objects or waterdrops to enter the w/ converter inverter assembly.
a. Connect the 2 connectors and 2 grommets to the w/ converter inverter assembly.
7. CONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR
CAUTION: Wear insulating gloves.
NOTE:
-
Make sure that the inverter converter is temporarily installed before working on the converter inverter assembly.
-
Do not allow any foreign objects or waterdrops to enter the w/ converter inverter assembly.