HOOD - ADJUSTMENT: DOOR / HATCH HOOD ADJUSTMENT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- ADJUSTMENT › HOOD - ADJUSTMENT: DOOR / HATCH HOOD ADJUSTMENT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
HOOD - ADJUSTMENT: DOOR / HATCH HOOD ADJUSTMENT

DOOR / HATCH HOOD ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:

· Centering bolts are used to mount the hood hinge to the vehicle body and hood. The hood cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
· A bolt without a torque specification is shown in the standard bolt chart.
BOLT>SPECIFIED TORQUE FOR STANDARD
BOLTS
*1 Centering Bolt *2 Standard Bolt
PROCEDURE
53117C
1.REMOVE NO. 1 RADIATOR GRILLE RETAINER
53301
2.ADJUST HOOD SUB-ASSEMBLY
a. Adjust the hood position.

i. Loosen the 4 hinge bolts on the hood and adjust the hood position. ii. Move the hood and adjust the clearance between the hood and front fender. iii. Tighten the 4 hinge bolts on the hood after the adjustment. Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)
b. Adjust the cushion rubbers so that the hood and fender are aligned.
HINT: Raise or lower the front end of the hood by turning the cushion rubber.
Parts & tools for this job For Toyota Hilux
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Toyota touch up paint
- PARTPanel clip assortmentSearch: Toyota panel clips assortment
As an Amazon Associate we earn from qualifying purchases.