Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

Fuel Gauge - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Body Electrical System › Fuel Gauge - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70Fuel Gauge - Toyota Land Cruiser J70 Workshop Manual

Fuel Gauge

1984 LJ70 RJ70 Repair Manual 38261E: diagram

BODY ELECTRICAL SYSTEM — Instruments, Gauges and Warning Lights BE-28

Fuel Gauge

Fuel Receiver Gauge 45V Ignition Switch (;

INSPECTION OF FUEL GAUGE

INSPECT RECEIVER GAUGE OPERATION

Battery (a) Disconnect the connector from the fuel sender gauge. Connect the positive (+) lead from the voltmeter to terminal 1 and connect the negative (—) lead from the voltmeter to terminal 1. (b) Turn the ignition switch or starter switch on. Check that the meter needle vibrates near the 3.5V position. If voltage is not correct, remove and test the receiver gauge.

MEASURE RECEIVER GAUGE RESISTANCE

Measure the resistance between terminals 1 and 2. Resistance: Approx. 55 2 If resistance value is not as specified, replace the receiver gauge.

1362 H1361

MEASURE SENDER GAUGE RESISTANCE

1984 LJ70 RJ70 Repair Manual 38261E: diagram

(a) Check that resistance changes as the float is moved from the top to bottom position. (b) Measure the resistance between terminal 1 and the sender gauge body for each float position. Float position mm (in.) Resistance (2) ) J 76.7 (3.020) | 3221 Ee | 302.4 (11.905) me | 189.8 (7.472) _

32.5448 110 + 77] 8E0732

If each resistance value is not as shown in the table above, replace the sender gauge.

Water Temperature Gauge

INSPECTION OF WATER TEMPERATURE

GAUGE Water Temperature 45V Receiver Gauge

1.

INSPECT RECEIVER GAUGE OPERATION

Ignition Switch (a) Disconnect the connector from the sender gauge. Connect the positive (+) lead from the voltmeter to terminal and connect the negative (—) lead from the voltmeter to body ground. (b) Turn the ignition switch or starter switch on. Check that the meter needle vibrates near the 3.5V position. If voltage value is not correct, remove and test the receiver gauge.

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.