Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

CHECK AND ADJUSTMENT - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Clutch › CHECK AND ADJUSTMENT - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70CHECK AND ADJUSTMENT - Toyota Land Cruiser J70 Workshop Manual

CHECK AND ADJUSTMENT

1984 LJ70 RJ70 Repair Manual 38261E: diagram

CLUTCH — Check and Adjustment of Clutch Pedal, Bleeding of Clutch System CL-3

CHECK AND ADJUSTMENT OF

Push Rod Play Adjust Point

CLUTCH PEDAL

1,

CHECK THAT PEDAL HEIGHT AND PUSH ROD

Pedal Height

PLAY ARE CORRECT

Adjust Point Pedal height: 186 mm (7.32 in.) Push rod play at pedal top: 1 — 5 mm (0.04 — 0.20 in.) If incorrect, adjust the pedal height and push rod play.

2.

IF NECESSARY, ADJUST PEDAL HEIGHT AND

PUSH ROD PLAY

(a) Loosen the lock nut and turn the stopper bolt until the height is correct. Tighten the lock nut. (b) Loosen the lock nut and turn the push rod until the push rod play is correct. Tighten the lock nut.

3.

CHECK THAT PEDAL FREEPLAY IS CORRECT

Push in on the pedal until the beginning of clutch resist: ance is felt. Pedal freeplay: LJ 5—15 mm (0.20 — 0.59 in.) RJ 13 — 23 mm (0.51 — 0.91 in.)

1F NECESSARY, ADJUST PEDAL FREEPLAY

4. | :

Loosen the lock nut and turn the push rod until the

(a)

\\\ Pedal Freepl

freeplay is correct. (b) Tighten the lock nut.

After adjusting the pedal freeplay, check the pedal

{c) height.

\ oo

BLEEDING OF CLUTCH SYSTEM

NOTE: If any work is done on the clutch system or if air is suspected in the clutch lines, bleed the system of air.

1984 LJ70 RJ70 Repair Manual 38261E: diagram

CAUTION: DO NOT let brake fluid remain on a painted surface. Wash it off immediately. 1,

FILL CLUTCH RESERVOIR WITH BRAKE FLUID

Check the reservoir frequently and add fluid if necessary. too

2.

CONNECT VINYL TUBE TO BLEEDER PLUG

Insert the other end of the tube in a half-full container of brake fluid.

3.

BLEED CLUTCH LINE

(a) Slowly pump the clutch pedal several times. (b) While pressing on the pedal, loosen the bleeder plug until the fluid starts to run out. Then close the bleeder plug. son ws) (c) Repeat this procedure until there are no more air bubbles in the fluid.

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.