Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

Heel Contact - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Rear Axle Suspension › Heel Contact - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J70Heel Contact - Toyota Land Cruiser J70 Workshop Manual

Heel Contact

1984 LJ70 RJ70 Repair Manual 38261E: diagram

REAR AXLE AND SUSPENSION — Differential RA-21

Heel Contact

C tL—=— Face Contact

Select an adjusting shim that will bring the drive pinion closer to the ring gear. Proper Contact

Flank Contact

Toe Contact

a) t ~ Select an adjusting shim that will shift the drive pinion away from the ring gear.

Ra0029 If the teeth are not contacting properly, use the following. chart to select a proper washer for correction. Washer thickness Thickness mm (in.)

1.70 (0.0669)

2.03 (0.0799)

1.73 (0.0681)

2.06 (0.0811)

1.76 (0.0693)

2.09 (0.0823) Washer

1.79 (0.0705)

2.12 (0.0835)

1.82 (0.0717)

2.15 (0.0846) 84098

1.85 (0.0728)

2.18 (0.0858)

1.88 (0.0740)

2.21 (0.0870)

1.91 (0.0752)

2.24 (0.0882)

1.94 (0.0764)

2.27 (0.0894) 1,97 (0.0776)

2.30 (0.0906)

2.00 (0.0787)

2.33 (0.0917) 7,

REMOVE COMPANION FLANGE

(See step 7 on page RA-9) D b—

8.

REMOVE FRONT BEARING

—- -

(See step 9 on page RA-9)

e086

9.

INSTALL NEW BEARING SPACER AND FRONT

BEARING (a) Install a new bearing spacer on the shaft. (b) Install the front bearing on the shaft. 10,

INSTALL OIL SLINGER AND NEW OIL SEAL

(a) Install the oil slinger facing as shown. (b) Using SST, drive in a new oil seal as shown. SST 09554-30011 Oil seal drive in depth:

1.0 mm (0.039 in.) nooo (c) Apply MP grease to the oil seal lip.

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.