Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
c. Tie both piano wire ends to wooden blocks or similar objects.
d. Cut the adhesive tape by pulling the piano wire.
NOTE:
-
If reusing the moulding, take care not to damage the moulding.
-
Do not damage the door panel.
e. Remove the moulding.
5. REMOVE REAR DOOR OUTSIDE MOULDING SUBASSEMBLY
a. Remove the 3 screws.
b. Using a moulding remover, remove the rear door outside moulding sub-assembly.
HINT: Tape the moulding remover tip before use.
c. Remove the 3 screws and quarter opening retainer.
6. REMOVE QUARTER OUTSIDE MOULDING
a. Remove the 3 screws.
b. Using a moulding remover, remove the quarter outside moulding.
HINT: Tape the moulding remover tip before use.
7. REMOVE REAR BUMPER EXTENSION
a. Remove the 4 screws and rear mudguard.
b. Remove the rear bumper cover.
c. Remove the 4 nuts and rear bumper extension.
INSTALLATION
1. INSTALL REAR BUMPER EXTENSION
a. Install the rear bumper extension with the 4 nuts.
Torque: 5.0 N.m (50 kg.cm, 43 in.lb)
b. Install the rear bumper cover.
c. Install the rear mudguard with the 4 screws.
2. INSTALL QUARTER OUTSIDE MOULDING
Install the quarter outside moulding with the 3 screws.