Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. INSTALL REAR DOOR OUTSIDE MOULDING SUBASSEMBLY
a. Install the quarter opening retainer with the 3 screws.
b. Install the rear door outside moulding sub-assembly with the 3 screws.
4. INSTALL REAR DOOR OUTSIDE MOULDING
a. Clean the rear door mounting surface.
1. Using a heat light, heat the rear door mounting surface to 40 - 60 °C (104 - 140 °F)
2. Remove the adhesive tape from the rear door.
3. Wipe off the stain with cleaner.
b. If reusing the moulding:
Clean the rear door outside moulding.
1. Using a heat light, heat the moulding to 20 - 30 °C (68 - 86 °F)
NOTE: Do not heat the moulding excessively.
2. Remove the adhesive tape from the moulding.
3. Wipe off the stains with cleaner.
4. Apply new adhesive tapes to the moulding.
c. Install the rear door outside moulding.
1. Using a heat light, heat the rear door panel and moulding
Rear door panel: 40 - 60 °C (104 - 140 °F)
Moulding: 20 - 30 °C (68 - 86 °F)
NOTE: Do not heat the rear door and moulding.
2. Lift the moulding release sheet from face of moulding.
NOTE: When the moulding release sheet is removed, make sure that no dirt or dust can get onto the uncoated area.
3. Align the boss with the corresponding hole in rear door, and press firmly on the moulding.
5. INSTALL FRONT DOOR OUTSIDE MOULDING
a. Clean the front door mounting surface.
1. Using a heat light, heat the front door mounting surface to 40 - 60 °C (104 - 140 °F)
2. Remove the adhesive tape from the front door.
3. Wipe off the stain with cleaner.
b. If reusing the moulding:
Clean the front door outside moulding.
1. Using a heat light, heat the mounting to 20 - 30 °C (68 - 86 °F)
NOTE: Do not heat the moulding excessively.
2. Remove the adhesive tape from the moulding.
3. Wipe off the stains with cleaner.
4. Apply new adhesive tapes to the moulding.