Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
3. REMOVE DISC
(a) Release the parking brake lever.
(b) Place matchmarks on the disc and rear axle hub.
(c) Remove the disc.
HINT:
-
If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.
-
If there are no matchmarks, temporarily install the disc, then measure the disc runout and install the disc in position.
4. REMOVE SHOE RETURN SPRINGS
Using needle-nose pliers, remove the 2 shoe return springs.
5. REMOVE SHOE STRUT WITH SPRING
HINT: At the time of reassembly, install the strut with the spring facing forward.
6. REMOVE SHOE ADJUSTER
Slide the front shoe toward outside, remove the shoe adjuster.
7. REMOVE FRONT SHOE
(a) Using a needle-nose pliers, disconnect the anchor spring and tension spring from the front shoe.
(b) Remove the anchor spring and tension spring.
(c) Using a clip remover, remove the front shoe with holding the cup.
HINT: At the time of reassembly, hold the cup with clip remover. In this condition, install the front shoe.
(d) Remove the 2 cups, shoe hold-down spring and pin.
8. REMOVE REAR SHOE