Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
c. Separate the wire harness from the reclining adjuster in side cover.
14. REMOVE ARMREST
a. Open the fastener.
b. Remove the bolt and armrest.
INSTALLATION
NOTE: Never use airbag parts from another vehicle. When replacing parts, replace them with new parts.
1. INSTALL ARMREST
a. Install the armrest with the bolt.
Torque: 37 N.m (380 kg.cm, 27 ft.lb)
b. Close the fastener.
2. INSTALL SEATBACK ASSEMBLY
a. Temporarily install the seatback assembly.
b. Install the wire harness to the reclining adjuster inside cover.
c. Install the 4 bolts.
Torque: 43 N.m (440 kg.cm, 32 ft.lb)
NOTE:
-
Make sure that the seatback assembly is installed with the specified torque.