Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
b. Remove these parts from the magnetic switch assembly:
1. Starter housing
2. Return spring
3. Idler gear
4. Bearing
5. Starter clutch assembly
HINT: At the time of assembly, please refer to the following items.
Apply grease to the return spring and insert the return spring into the clutch shaft hole.
3. REMOVE STEEL BALL
Using a magnetic finger, remove the steel ball from the clutch shaft hole.
HINT:
At the time of assembly, please refer to the following items. Apply grease to the steel ball and insert the steel ball into the clutch shaft hole.
4. REMOVE BRUSH HOLDER
a. Remove the 2 screws with O-ring and end cover from the field frame
Torque: 3.8 N.m (39 kgf.cm, 34 in..lbf)
b. Remove the O-ring from the field frame.
HINT:
At the time of assembly, please refer to the following items.
Use a new O-ring.