Sequoia LTD 4WD V8-4.7L (2UZ-FE) (2001)
Using SST, remove the front bearing from the drive pinion.
SST 09556-22010
6. REMOVE BEARING SPACER
a. Remove the 2 washers.
b. Remove the bearing spacer.
7. INSTALL NEW BEARING SPACER
a. Install a new bearing spacer.
b. Install the 2 washers.
8. INSTALL FRONT BEARING
a. Place the front bearing.
b. Using SST and the companion flange, install the front bearing then remove the companion flange.
SST 09950-30011 (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03050)
9. INSTALL NEW OIL SEAL
a. Coat a new oil seal lip with MP grease.
b. Using SST and a plastic hammer, install the oil seal until its surface is flush with the differential carrier end.
SST 09316-12010, 09649-17010
HINT: Connect 2 SST with vinyl tape.
10. INSTALL COMPANION FLANGE
a. Place the companion flange on the drive pinion.
b. Coat the threads of a new nut with hypoid gear oil.
c. 2WD: Install the companion flange nut.
1. Install the 3 stud bolts to make the heads 40 mm (1.5748 inch) out.